AirMan PDS185S-6E1, Руководство по обслуживанию

Страница: 33 / 103

2. Maintenance
2-14
PC08022
2.10 Air Bleeding in Fuel Line
●
Should the machine stop due to fuel shortage, perform air bleeding according to the following
steps.
<Procedure>
①
Replenish fuel.
②
When starter switch is turned to
“RUN”
position, electromagnet pump starts to automatically
bleed air in fuel line.
③
Air bleeding is completed about 1 minute.
 Engine will never startup until finish air breeding even though starter switch is turned
to “START” position.
 Never hold the key in the “START” position for longer than 15 seconds or the starter
motor will overheat.

When the engine fails to startup even after performing the startup procedures, do not
keep the starter running, but set the starter switch back to “STOP” and wait about 2
minutes. Then, repeat the startup procedure once again.
2.11 Clean Inside of Fuel Tank
●
Condensate is caused and accumulated at the bottom of fuel tank, owing to churning of dust or
dirt mixed when fuel oil is fed and water drop caused while fuel oil tank is used for a long time.
When any condensate is found afloat and fuel filter gets clogged too fast, fuel oil tank should be
cleaned after condensate is removed from fuel oil tank even before the specified cleaning interval
time.
<Procedure>
①
Open drain valve to remove fuel oil from fuel tank.
②
Remove side cover under door.
③
Remove fuel pipes and wires connected to fuel tank.
④
Remove belt holding fuel tank and remove tank.
⑤
Insert cleansing nozzle through fuel filler port or
drain port for cleaning tank.
⑥
After cleaning job is finished, install fuel tank from
which water or the like should be completely
removed.
Discount-Equipment.com