11
INSTALLATION
Installing the top
The appliance is designed to be embedded into
heat-resistant pieces of furniture.
The walls of the pieces of furniture must resist a
temperature of 75°C besides the room one.
The gas hobs are equipped with type X degree
protection against overheating. Therefore,
the appliance can be installed next to cabinets,
provided the height of the cabinet doses not
exceed that of the hob.
The equipment must not be installed near
inflammable materials, such as curtains, cloths,
etc.
Make a hole in the top of the piece of furniture,
with the dimensions indicated in fig. 3, at a
distance of at least
50 mm from the
appliance border to
the adjacent walls.
MODEL
L (mm)
P (mm)
AT635HIX
560
480
Any possible wall unit over the cook-top must be
placed at a distance of at least 760 mm from the
top.
It is advisable to isolate the appliance from the
piece of furniture below with a separator, leaving a
depression space of at least 10 mm (fig. 4).
If the hob is going to be installed on the top of an
oven, precautions must be taken to guarantee an
installation in accordance with current accident
prevention standards. Pay particular attention to
the position of the electric cable and gas pipe: they
must not touch any hot parts of the oven.
Moreover, if the
hob is going to be
installed on the top
of a built in oven
w i t h o u t f o r c e d
cooling ventilation,
proper air vents
must be installed
to guarantee an
adequate ventilation,
with the lower air entering with a cross section of
at least 200cm
2
, and the higher air exiting with a
cross section of at least 60 cm
2
.
Fastening the top
Every cook-top is equipped with a special washer.
A set of hooks is also supplied for mounting the
cook-top.
For the installation proceed as follows:
-Remove the racks and burners from the top.
-Turn the appliance upside down and lay the
washer S along the external border (fig. 5).
Fig.5
Fig.6
-Introduce and place the cook-top in the hole made
in the piece of furniture, then block it with the V
screws of the fastening hooks G (fig.6.
Installation room
This appliance is not provided with a device for
exhausting the products of combustion. Regarding
room ventilation rules where appliance is installed
make reference to the legislation, in conformity
with the local regulations.
FOR THE U.K. ONLY
The room containing this hotplate should have an
air supply in accordance with BS 5440: Part 2:
1989.
INSTRUCTIONS FOR THE INSTALLER
IMPORTANT NOTICE:
THE OPERATIONS INDICATED BELOW MUST BE FOLLOWED BY QUALIFIED
PERSONNEL EXCLUSIVELY, IN CONFORMITY WITH THE REGULATIONS IN FORCE.
THE MANUFACTURING FIRM REFUSES ALL RESPONSIBILITY FOR DAMAGES TO
PEOPLE, ANIMALS OR THINGS, RESULTING FROM THE FAILURE TO COMPLY WITH
SUCH PROVISIONS.
Fig.3
Fig.4
Содержание AT635HIX
