Air Creation BioniX2 13, Руководство по обслуживанию

Страница: 32 / 50

GDMMBi²13-1G Version 0010 32
Figure 5-35 Figure 5-36

Refer to drawings Y153030 & UO28271-M100 .

The fine cord of the CORSET has a knot on the end near the control lever. Thread the cord in
the hole on the flat surface of the
cone-shaped pulley D274011 of the control lever by the
free end and pull it until the knot is blocked in its housing.

Assemble the controls of the CORSET and its cone-shaped pulley on the right base so that the
body is slightly turned towards the center of the A-frame (about 25°) and positioned nearest to
the attachment of the lower front cable, which corresponds to the measurement indicated in
drawing
OP10-35CO . Do not tighten screw CHC 6-20 B062010 too tightly (the threading is
nylon). If dual control bars have been installed for instruction, the body should be turned
towards the outside of the A-frame in order to allow for the full rotation of the handle. Figure
5-37.
Figure 5-37 Figure 5-38

Thread the fine cord in the four guides of the right A-frame strut then on the pulley of the
hang point bracket, then wrap it around the pulleys of the hoist and through the hole in the
adjusting screw near the trailing edge, as shown in drawing
OP10-35CO . Tie a figure eight
knot right behind the adjusting screw to tighten the retaining straps of the hoist without
constraining the protection plate. Tighten the CORSET to the maximum using the lever. You
should be able to tighten by hand the slack of the fine cord behind the adjusting screw,
5
more centimeters , before the front pulleys of the hoist make contact. Adjust the position of
the knot to obtain these 5 centimeters. Check by measuring the axel spread between the two
central nose battens at the point of
screw 6-25 B062510 securing the guides of the central
batten of the trailing edge. A precise measurement of 455mm should be obtained. Adjust the
position of the knot slightly if necessary. Thread the plastic finishing cap, cap for bungee
P230010 , tie a figure eight knot at the end of the fine cord, and close the cap. Figure 5-38.