Air Creation BioniX2 13, Руководство по обслуживанию

Страница: 26 / 50

GDMMBi²13-1G Version 0010 26
Figure 5-17
Figure 5-18

Position the nose battens on the nuts of the fastening bolts of the leading edge above the nose
plates, against the stop washers
D274080 . Figure 5-19.

Open the leading edge progressively to the maximum, while checking that the lateral cables
deploy properly at their ends without loops or knots at the neoprene openings of the sail.
Proceed in small steps, going back to the nose of the wing to pull the sail forward and insure
that the central battens stay in place on the nuts of the leading edge. Help the deployment of
the sail on the frame by pulling it backwards on the keel and at the tips of the wing if it is not
centered.

Fasten the retaining straps of the sail to the end of the nose battens and the CORSET batten
guides of the lateral batten of the trailing edge, as shown in drawing
UO28271-M0140 and
OP10-22VO. Figure 5-20.
Figure 5-19 Figure 5-20
6. Upper Surface Battens

Put in place the lateral battens, internal carbon battens D190910 , of the exterior luff lines.
Open the 2 zippers sewn along the under surface battens in front of the lower lateral cables in
order to slide you hand and the batten itself. Fasten the Velcro strips to hold the battens in
position. Close the under surface zippers. Figure 5-21.

Insert the upper surface battens in their pockets. The battens whose tips are red belong on the
left side of the wing.

Install the batten tighteners P235020 on the straps of the trailing edge. Figure 5-22.