- Page 45 -
Note:
You can find and download the complete Installation guide at
our web site
www.aiptek.de
under "Technische Hilfe / Anleitungen"
Win98-Users
: Please be sure that your operating system is Windows
98 SE (second edition). The camera will not function properly using
the Windows 98 (first edition) operating system
¾
The Live Mode functions properly but downloading pictures and
videos in not possible.
This problem could occur if the drivers were not properly installed. The
drivers include three components that windows will automatically
install and integrate into your system one after another. If one or more
components were improperly installed, some features may not
available or operate correctly
Note:
You can find and download the complete Installation guide at
our web site
www.aiptek.de
under "Technische Hilfe / Anleitungen"
.
¾
When I open the Mega Cam Manager I receive the message
”Camera can not be connected” or “Camera busy”.
If you receive this message, there could be a number of reasons for
this problem. Please refer to the following possibilities:
When you connect the camera to the USB – Port, the camera should
automatically turn on (check the display on the reverse side of the
camera). Remove the batteries from the camera and connect –
disconnect – connect the camera from the USB Cable. You should
hear a short beep and the camera should turn on automatically.
If the camera remains off, then the camera is most likely defect or the
USB Port is not supplying enough power to the camera. Try installing
the camera to a different computer if possible. If the camera installs
properly then the problem is due to a faulty operating system.
Ensure that the camera has been correctly recognised by your
operating system. Go to the Device Manager and connect the camera
to the USB Cable. Three new components should appear, one under
Cameras and Scanners and two under Universal Serial Bus
Controller. If not then the camera has not been properly recognised.
Note:
You can find and download the complete Installation guide at
b it
i t k d
d
"T h i h Hilf / A l it
"
- Page 46 -
¾
The PC crashed when making videos from the PC-Mode using
Windows 98SE
This problem can occur when the DMA of the hard drive controller is not
activated (Windows 98SE default setting).
Do the following to check the DMA-mode setting:
Open the device manager and click on the “+” next to the entry “drives”.
Double click on “GENERIC DISK TYPE” then click on “Settings”.
Under “Options” you will see a box next to DMA. Click on this box to
activate the DMA-mode. You must reboot the computer in order for the
changes to take effect.
Attention:
Not all hard drives support the DMA-mode. Refer to your
manual or contact the manufacture to see if your hard drive is
supported.
