Agromehanika AGT 106, Руководство по эксплуатации

Страница: 93 / 245

OPERATING INSTRUCTIONS AGT 1060 Rev.09/2020
92
Fig. 97
4.9.6 HYDRAULIC BRAKE ON A TRAILED IMPLEMENT
Optionally, the tractor can also be equipped with a system for connecting trailed implements
with a hydraulic brake.
Operation
When the brake pedal is depressed, the valve on the hydraulic brake redirects the oil from the
pressure circuit through a hydraulic conductor to the braking system of the trailed implement and
the implement starts to brake.
Connecting the hydraulic connection hose
The male hydraulic coupling on the brake valve with a size of ⅜

allows for the connection of
the female connector of the connection hose.
To connect the hydraulic connection hose:
•
Stop the tractor when the conditions are safe.
•
Shut off the tractor's engine (the key must be in position 0, refer to the chapter “Ignition
key”).
•
Insert the hydraulic connection hose into hydraulic coupling of the brake valve on the
tractor.
•
When connected, start the tractor’s engine and make sure the hydraulic system operates
properly.
•
Depress the brake pedal a few times to equalize the pressure in the hydraulic braking
system of the implement.
Disconnecting the hydraulic connection hose
•
Stop the tractor when the conditions are safe.
•
Shut off the tractor's engine (the key must be in position 0).
•
Disconnect the hydraulic connection hose. Push the hose forwards and pull the safety
device towards you to activate and release it, then push the coupling back.
Maximum output pressure of the hydraulic coupling is 140 bar!