OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
159
7.12
EXTENDED PERIOD OF INACTIVITY AND RESTARTING THE TRACTOR
This chapter provides instructions in case the tractor will not be used for a while, for example,
before the winter season.
7.12.1
EXTENDED PERIOD OF INACTIVITY OF THE TRACTOR
If the tractor will not be used for some time, carry out the following operations to ensure that
some vital components remain functional.
•
Start the engine and leave it running in idle for a few moments or until it is heated.
•
Stop the tractor's engine and allow it to cool down.
•
Discharge the old engine oil and replace with new oil of the same type; replace the oil
filter at the same time.
•
Clean the radiator and, if necessary, top up with an appropriate coolant.
•
Fill the fuel tank to prevent unnecessary condensation.
•
Check the condition of the fuel filter and replace it if necessary.
•
Clean or replace the air filter.
•
Remove the battery, clean it and check its voltage. If necessary, charge the battery and
store it in a dry and cool area.
•
Clean the external surfaces of the tractor. In case of scratches or abrasions, coat with
appropriate paint to prevent corrosion.
•
Protect the metal surfaces which cannot be painted with a lubricant or an anti-corrosion
product.
•
Keep the tractor stored in a dry and protected area. If the tractor is stored outdoors, cover
it with a protective waterproof awning.
•
To protect the tyres, it is recommended to park the tractor in an area protected from direct
heat and sunlight.
•
To maintain the tractor in a good technical condition, it is recommended to occasionally
start the tractor’s engine and leave it running in idle for at least 15 minutes.
7.12.2
RESTARTING THE TRACTOR
Before restarting the tractor after an extended period of non-use, check all vital components and
make sure they are in perfect working order. For this reason, it is particularly important to follow
the instructions given below before operating the tractor again.
•
Install the charged battery back in its place and connect it, refer to “Changing the
battery”.
•
Check the levels of all fluids (oil, coolant, fuel).
•
Check the hydraulic system (leakage, level of hydraulic oil).
•
Lubricate all greasing points.
•
Check all safety devices on the tractor for proper operation.
•
Check the tyres for wear and pressure.
•
Clean any dirt from the driver’s area and control devices.
•
Start the engine and leave it running in idle for a few moments or until it is heated.
WARNING:
Do not start the tractor in closed areas or areas with poor ventilation.
Exhaust gas is very dangerous and may cause asphyxiation.
Содержание AGT 106
