OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
113
Fig. 127
Fig. 128
6.2.1.1
ADJUSTMENT
To determine the projection points of headlights on the wall, drive the tractor to the wall with the
headlights on, mark the middle point of the light beam, then back-up the tractor until it is 5 m
from the wall.
To adjust the lateral position and the height of the headlights, use the screws shown in the figure.
Perform the following procedure to access the screws.
•
Open the engine cover.
•
Adjust the headlight position by
tightening or loosening the screws.
•
Close the cover and check the beam.
If necessary, repeat the procedure.
When the adjustment is finished, the distance
between the projection points on the wall
must match the distance between the
headlights.
6.2.2
ADJUSTING THE WORKING LAMPS
Adjusting the lamps up and down
, this adjustment can be performed manually. If this is not
possible, do the following:
•
First, loosen the screw on the articulated part of lamps.
•
Manually adjust the position of lamps to reach the desired illumination angle and tighten
the screw.
IMPORTANT:
As a road user, you must ensure that the headlights are correctly
positioned to avoid disturbing the other drivers on the road!
Содержание AGT 106
