Agromehanika AGT 106, Руководство по эксплуатации

Страница: 150 / 245

OPERATING INSTRUCTIONS AGT 1060 Rev.09/2020
149
Fig. 174
7.8.2 CONNECTING AND DISCONNECTING THE IMPLEMENT ON THE FRONT
HYDRAULIC LIFT MECHANISM
The description of the connection procedure is based on the assumption that the front hydraulic
lift mechanism is already adjusted for the implement, otherwise a new adjustment is required
first, refer to the chapter "Adjusting the front hydraulic lift mechanism".
When disconnecting, you must keep in mind that the ground on which you are going to perform
the procedure must be level and solid to ensure good positioning and stability of the implement
in a free-standing position, while making sure that it does not obstruct and endanger other
persons.
To connect the implement to the tractor, follow the procedure below.
•
Install the ball joint (1) to the bolts on the implement and secure it with a safety pin (2).
•
Drive the tractor to the implement.
•
Using the lever on the control device (3), lift the lower link arms (4) until they are
properly locked in the ball joints.
•
Stop the tractor and make sure the conditions are safe.
•
Install the top link (5) to the tractor and to the third linkage point on the implement.
Install the bolt (6) on both sides and secure it with a safety pin (7).
•
Lift the implement using the lever on the control device.
•
If the implement is not parallel to the ground, adjust the top link to an appropriate length,
refer to “Adjusting the top link”.
•
Fold the support legs (if equipped).
•
Connect all electrical and hydraulic connections of the implement to the connection
system on the tractor.