AGRI EASE BE-TMS Series, Руководство по эксплуатации и запасным частям

Страница: 15 / 32

BE-TMSXXXX USER MANUAL
15
Application to the tractor
WARNING
Clean and clear the installation area from any obstruction before starting to work.
The area must be specifically closed off and personnel not assigned to the works must be made to move
away. The available means must be verified to be intact and suitable. The operator must also tighten all the
bolts and fittings properly, using suitable tools.
DANGER
All the following assembly and installation operations must be carried out with the tractor engine switched
off.
The application of the mulcher to the tractor must take place on flat ground. All the cutters are applicable to
any tractor equipped with a universal three-point hitch. The Manufacturer declines all responsibility for the
breakage of the tractor. Proceed as follows for the coupling (Fig. 6):
• Use appropriate protective gloves to move the tractor back until the lifter bars are inside the plates (A) and
(B). Insert the pin into the preset hole and secure it with the split pins.
• Switch the tractor off and engage the parking brake.
• Lock the lifter bars on the tractor with the appropriate chains and parallel tighteners: this precaution must
take place in order to avoid any transversal movement of the Mulcher.
WARNING
Clean and clear the installation area from any obstruction before starting to work.
The area must be specifically closed off and personnel not assigned to the works must be made to
move away. The available means must be verified to be intact and suitable. The operator must
also tighten all the bolts and fittings properly, using suitable tools.
APPLICATION TO THE TRACTOR BE-TMSxxxx
DANGER
All the following assembly and installation operations must be carried out with the
tractor engine switched off.
The application of the mulcher to the tractor must take place on flat ground. All the cutters are applicable to
any tractor equipped with a universal three-point hitch. The Manufacturer declines all responsibility for the
breakage of the tractor. Proceed as follows for the coupling (Fig. 6):
-- Use appropriate protective gloves to move the tractor back until the lifter bars are inside the plates (A) and (B).
Insert the pin into the preset hole and secure it with the split pins.
-- Switch the tractor off and engage the parking brake.
-- Lock the lifter bars on the tractor with the appropriate chains and parallel tighteners: this precaution must
take place in order to avoid any transversal movement of the Mulcher.
B
A
C
Fig. 6
• Engage the Cardan shaft and make sure that it is perfectly locked on the power take-o .
• Verify that the protection rotates freely and secure it with the appropriate chain. Remove the support from
the Cardan shaft.
• Connect the upper point (C), securing it with the appropriate pins and split pins, and use the tie-rod to
adjust correctly, making sure that the upper surface of the Mulcher is parallel to the ground. This is very
important in order to obtain parallelism between the cutter power take-o shaft axle and the tractor power
take-off. Operating in these conditions means limiting the stresses on the power take-o and prolonging the
duration of the Cardan shaft and the Mulcher itself.
• The correct position of the tractor / Mulcher unit is such when the mulcher is at a distance from the tractor
so that the cardan shaft does not extend beyond 5-10 cm from the maximum closing position.
• If the machine is provided with lateral hydraulic displacement (optional), connect the two hydraulic hoses
of the Muncher to the special connections on the tractor (Fig. 7).
• Engage the PTO and accelerate up to a minimum of 400 rpm. Then test lift the Mulcher to verify proper
operation.