Using the Front Panel Menu
Series N6700 User’s Guide
31
Sel
The command menu is now at the function control level. This is the lowest
level in this path. Two over-voltage function controls are available.
Use the navigation keys to highlight the Enable OVP control. This control
enables or disables over-voltage protection. Pressing SEL or Enter will check
or uncheck this control.
Use the navigation keys to highlight the OVP Level control as shown below.
Enter the desired over-voltage level using the numeric keypad. Then press
Enter.
Channel
Press the Channel key at any time to select a different output channel. This
can save time because you can directly access the OVP control of each
channel without having to navigate through the menu levels.
NOTE
If you program an over-voltage protection level that is lower than the present
output voltage, the over-voltage protection circuit will trip and turn the output
channel off. The status indicator will show OV.
Exiting the Command Menu
There are two ways to exit the command menu.
Press the
Meter
key to immediately return to the metering
screen. This is the quickest way to return to metering mode.
Press the
Back
key to back up one level at a time in the command
menu. This method may be more convenient if there are other
menu commands to be given.
Detailed instructions on how to use the power system’s functions and
capabilities are found in the next chapter. Detailed information about
the SCPI programming commands are found in chapters 5 and 6.
In Case of Trouble
Press the
Help
key to obtain additional help about any function
control menu level. Press the
Back
key to exit the Help menu.
If the self-test fails, or if other operating problems occur with your
instrument the Err annunciator comes on. Press the
Error
key to
display the list of errors. Refer to Appendix D for further
information.
