Agilent Technologies E2050, Руководство по установке и настройке

Страница: 83 / 111

Chapter 5 83
Troubleshooting
Gateway Failure Messages
Gateway Failure Messages
This section provides failure messages and troubleshooting explanations for
the E2050 LAN/GPIB Gateway, including:
n
SICL Error Codes and Messages
n
syslog File Messages
SICL Error Codes and Messages
The following table lists some common SICL error codes and messages a
client application may encounter when using the E2050 LAN/GPIB Gateway.
Error Code Error Message Troubleshooting Tips
I_ERR_BADADDR
Bad address The device/interface address passed to
iopen
does not
exist. Use the Telnet commands to verify that the
hpib-
address:
,
hpib-name:
, and
hpib-unit:
configuration
values are correct.
I_ERR_NOCONN
No connection The communication session with the Gateway was never
established or the connection to a remote Gateway was
dropped. Use the Telnet
status
command and any error
messages logged to a
syslog
file for more information.
I_ERR_NORSRC
Out of resources No more resources are available. Use the Telnet
status
command and any error messages logged to a
syslog
file
for more information.
I_ERR_NOTSUPP
Operation not
supported May occur when using VXI-11 (TCP/IP Instrument Protocol)
when the
hpib-name
is set to hpib . Use the Telnet
configuration utility to change the
hpib-name
to gpib0 .
If this does not solve the problem, use the SICL LAN protocol
instead, as this protocol has more features than VXI-11.
I_ERR_SYMNAME
Invalid symbolic
name The symbolic name passed to
iopen
was not recognized.
Use the Telnet
hpib-name:
configuration value to verify
the configuration.
I_ERR_TIMEOUT
Timeout occurred A timeout occurred while performing an operation. The
device may be busy, in a bad state, or a longer timeout value
may be needed for the operation on the device. Verify the
correct address was used in
iopen
. Use the Telnet
status
command and any error messages logged to a
syslog
file
to get more information.