Agilent Technologies E2050, Руководство по установке и настройке

Страница: 45 / 111

Chapter 3 45
Configuration
Configuration Methods
Using Telnet Configuration Method (Windows)
To configure the LAN/GPIB Gateway on your network using the Telnet
configuration method from a Windows 95/98/2000/Me/NT client system:
1 Power-on the Gateway by plugging the AC power cord from the
power module into a power outlet (wall outlet).
2 Once the Gateway is powered on, press the
Config Preset
button
on the back panel of the Gateway. This causes the Gateway to
temporarily use its default IP address,
192.0.0.192
. The
LAN
Conn
(LAN Connect) LED on the front panel of the Gateway will
flash slowly, showing that the default IP address is now in use.
3 If not already running, start Windows 95/98/Me or Windows
2000/NT on the client computer system (the Windows PC).
4 From the Windows 95/98/Me task bar at the bottom of the screen,
select
Start
|
Programs
|
MS-DOS Prompt
. The MS-DOS window
opens. Or, from the Windows 2000/NT Program Manager, select
Main
. Then select
MS-DOS Prompt
. The MS-DOS window opens.
5 At the
>
prompt in the MS-DOS window, type:
route add 192.0.0.192
your_system_name
Enter
This sets up a route table entry on your client system for the
Gateway at its default IP address.
6 At the
>
prompt in the MS-DOS window, type:
telnet 192.0.0.192
Enter
This connects you to the Gateway at its temporary (default) IP
address and the Telnet window opens.
NOTE
If you are unable to make a Telnet connection using the default IP
address (
192.0.0.192
), try pressing the
Config Preset
button again and
then try the
telnet
command (Step 6). If you are still unsuccessful, see
Chapter 5 .