Agilent Technologies E2050, Руководство по установке и настройке

Страница: 68 / 111

68 Chapter 4
Administration
Using the Telnet Utility
Exiting the Telnet Utility
To exit the Telnet utility, use these Telnet commands.
n
If you want to exit without saving any changes (if any) you have
made to the configuration values, at the Telnet prompt (
>
) type
bye
(or)
exit
(or)
quit
.
n
If you want to save the changes you have made to the
configuration values via the Telnet utility, at the Telnet prompt
(
>
) type
reboot
.
n
Reset the Gateway to the default configuration values and
reboot the Gateway, at the Telnet prompt (
>
), type
factory-
reset
.
Telnet Commands
Table 4-1 lists the Telnet commands you can use to administer the E2050
LAN/GPIB Gateway. Many Telnet commands are for configuration purposes
only. These commands have a colon (“:”) and italicized value parameter
after them (for example,
allow:
IP_address(es) ).
You should use the Telnet configuration commands only if you are using the
Telnet configuration method to configure the Gateway. If, instead, you are
using the BOOTP or the BOOTP with TFTP configuration methods, follow
the procedures in
Chapter 3 .
You can see a summary of all the Telnet commands online by typing
?
at
any time within the Telnet utility.
CAUTION
Any client operations in progress and client connections will be
terminated by the
reboot
command.
CAUTION
Any client operations in progress and client connections will be
terminated by the
factory-reset
command when it reboots the
Gateway.