53210A/53220A/53230A Option Installation
43
53210A/53220A/53230A Option Installation
and tighten both of the SMA connectors using a 5/16" wrench.
8. Re- install the T20 TORX screw removed in step 2 above, securing the
rear flange on the Channel 3bracket to the motherboard with the screw.
9. Install the two supplied flathead screws through the holes in the
left- hand aluminum side panel into the embedded nuts on the bracket of
the Channel 3 assembly.
10. Re- install the Option 300 Internal Battery (if moved). Be sure to
re- connect any disconnected cables.
11. Re - install the cover, rear bezel, and handle (if applicable).
12. Install the supplied Option 106 label above the rear panel SMA con-
nector in the location provided.
53230A Option 150 (Pulse Microwave Measurements)
N O T E
If necessary, loosen the hex nut on the other end of the semi-rigid cable to align
the cable and then tighten all nuts. There should be no stress on the semi-rigid
cable.
N O T E
Option 150 is an internal firmware upgrade to the 53230A. There are no parts
associated with this option. However, this option requires that the 53230A has
either Channel 3 Option 106 (6.0 GHz) or Option 115 (15.0 GHz) installed.
N O T E
Option 150 may be obtained by ordering 53230U-150 from your nearest Agilent
Technologies Sales Office. Refer to the list of Sales and Service offices in the
Appendix for the sales office nearest to you.
