INTRODUCTION
02.4
Introduction
11-04
RoGator 418
Break-in Period
First 100 Hours of Operation
IMPORTANT: Change the engine oil and oil
filter after the first 100-150 service hours. This
should be done in connection with a 100 to 150
hour maintenance service performed by AG-
Chem Europe b.v. after making an appointment
with the Service Centre. Refer to the section
entitled "Maintenance" for the engine oil and
engine oil filter specifications. The running-in
instructions can be found in the engine operat-
ing and maintenance manual.
Hydraulic System
IMPORTANT: Replace the filter element of the
hydraulic suction/return line filter after the first
100 to 150 service hours.
(See "Maintenance" section.)
Check the oil level daily and watch for any possible
leaks.
Engine Coolant Level
Check the engine coolant level and watch for any
possible leaks.
WARNING
!
The cooling system is pressur-
ised. Scalding can occur if con-
tacting hot coolant. Do not
loosen the coolant reservoir cap
when the coolant is hot.
Wheel Mounting Bolts
1. Loosen each wheel mounting bolt 1/4 turn every
10 hours during the first 50 hours of operation
and then tighten opposite bolts to a torque of
250 Nm.
2. Retighten all bolts, but now to a torque of 515
Nm.
3. Repeat step 2 every 500 service hours. For
procedure see P. 6.11.
Maintenance Schedule
Check all items shown under the daily section of the
maintenance schedule, every day the machine is in
use.
Chassis and Cabin Modifications
IMPORTANT: It is not allowed to modify the
vehicle or auxiliary parts not approved by Ag-
Chem Europe b.v. or by the manufacturer of
the vehicle.
IMPORTANT: To prevent damage to the wiring
and hoses, never drill holes into the cabin. Be
particularly cautious with vertical pipes.
Towing the RoGator
If there is a problem that cannot be corrected on
the spot, transport the vehicle instead of towing it if
at all possible.
Towing with Engine Operable
The vehicle may be towed a short distance if nec-
essary.
IMPORTANT: When towing, run the engine at
idle speed to provide hydraulic power for steer-
ing and to release the parking brake. The ball
valves must be set at the traction drive mani-
fold so that the oil can still circulate without
pressure. Do not tow the vehicle at a speed of
more than 8 km/h.
Towing with Engine Disabled
IMPORTANT: If the engine can not be run, the
parking brake must be released.
Do not exceed a speed of 5 km/h as steering is
more difficult.
Also operate the ball cock valves.
IMPORTANT: if there is a problem that can not
be corrected in the field, TRANSPORT THE
VEHICLE INSTEAD OF TOWING THE VEHICLE
IF AT ALL POSSIBLE. Towing the vehicle is not
recommended, except in cases of emergency.
CAUTION
!
WARNING: Do not use a towing
rope, for it will produce a whip-
lash in case the rope breaks.
This can result in personal in-
jury.
Therefore always use a tow bar.
