MAINTENANCE
06.10
Maintenance
11-04
RoGator 418
Tyre Maintenance
Check the tyres for correct pressure
and damage every day.
WARNING
!
Wear eye protection and stand
away from the tyre while adding
air to prevent possible personal
injury from blow-outs, etc.
WARNING
!
Never exceed the tyre manufac-
turer's maximum recommended
inflation pressure. Do not ex-
ceed vehicle speeds and loads
shown on the Tyre Air Pressure
Chart.
Protect the tyres from long periods of contact with
fuel, grease oil and chemicals. Some chemicals
can damage rubber. Wash the tyres every day
after the application of chemicals. Air temperature
can have a large effect on the tyre pressure. At low
temperatures tyre pressure drops. At high tem-
peratures tyre pressure rises.
Tyre Mounting
WARNING
!
The driver / operator must be
aware that the tyres which may
be mounted on the rims have a
lower approved load than the
factory tyres. Personal injury or
death can result if the driver
does not observe this and ex-
ceeds either the load or speed of
the changed tyres of a lesser
quality.
WARNING
!
Failure to follow the correct in-
structions when installing a tyre
on a wheel or rim can produce
an explosion that can cause
personal injury or death. DO
NOT attempt to install a tyre
unless you have the correct
equipment and are trained and
qualified to perform the proce-
dures safely. Have all tyre repair
or replacements performed by a
trained and qualified tyre service
centre.
CAUTION
!
If the tyres must be replaced,
contact Ag-Chem Europe b.v.
The specifications of the new
tyres must be EQUAL or HIG-
HER than the specifications and
approved load of the old tyres.
The wrong selection of tyres
and/or the use of different types
of tyres can result in a loss of
control over the vehicle while
driving, which can lead to acci-
dents. The installation of: Used
and new tyres, bias-ply and ra-
dial-ply tyres, and tyres with
different diameters or load ra-
dius can lead to damage.
IMPORTANT: The air in the tyres may be re-
moved in order to be able to ship the vehicle.
Check the tyres and inflate them according to
the values specified in the above chart.
IMPORTANT: Certain tyres require a reduction
of the admissible maximum speed and load.
It is the responsibility of the driver to weigh the
vehicle and the product transported. If help is
required in determining the maximum product
quantity, contact Ag- Chem Europe BV .
