12
3.
Attach hotcupboard plinth to the AGA Total Control
plinth using M6 screws and washers provided (
Fig.
6.4
). Attach locking screw and jacking screw into
plinth. Make sure at this stage that the jacking screw
does not protrude beyond outer face of plinth. Ensure
locking screw is located into AGA TC3 plinth but not
fully tightened. A gap of approximately 3mm should
be present between the plinths apart from at the very
front where the hotcupboard spacer plate should be
touching the AGA TC3 plinth.
4.
Run a straight edge along the front of the AGA Total
Control plinth, to ensure the front face of both plinths
sit squarely against the straight edge (
Fig. 6.5
). When
satisfied both plinths sit squarely, jacking screws can
be tightened until they just make contact with the AGA
Total Control plinth, and locking screws can now be
tightened.
5.
Front jointing bracket can now be hooked into place
over the two pot magnets. This will latch the two plinths
together (
Fig. 6.6
).
DESN 516550
Fig. 6.4
DESN 516551
Fig. 6.5
USE STRAIGHT EDGE ACROSS BOTH PLINTHS TO ENSURE
PLINTHS ARE ALIGNED SQUARELY
DESN 516553
Fig. 6.6
Содержание TC3G
Страница 4: ......
Страница 19: ...15 7 Circuit Diagram AGA TC3 DESN 517487...