11
6. Hotcupboard Installation
NOTE:
The AGA TC5 hotcupboard should arrive with the top
plate in a jacked up position. This is to allow the complete
appliance to be slid onto its plinth when alongside the AGA
TC3 without the top plates clashing. The hotcupboard top
plate should then be wound down to its correct height once
the appliance is in its final position.
1.
Detach hotcupboard from plinth by removing two
screws and tongue bracket from plinth (
Fig. 6.1
),
slide hotcupboard forwards and away from rear fixing
bracket (
Fig. 6.2
).
2.
Position the plinth alongside the AGA Total Control
leaving no gap between the two plinths (
Fig. 6.3
).
Check with a spirit level that the plinth level is correct,
and also check height differential between the
hotcupboard plinth and Total Control plinth is correct
(11 mm). If necessary, use shims in each corner to level
the plinth.
Fig. 6.1
DESN 516448
DESN 516449
Fig. 6.2
Module
plinth base
3/8” (11mm) height
differential
DESN 516276
Fig. 6.3
Содержание TC3G
Страница 4: ......
Страница 19: ...15 7 Circuit Diagram AGA TC3 DESN 517487...