Aeroworks 60cc Freestyle Extra 260 Assembly Manual
21
12. Slide the upper and lower rudder control horn
into the pre-cut slots as shown. Ensure that the
control horn is centered on both sides before the
epoxy fully cures.
13. Apply 30 minute epoxy to the remaining base
plate and install on the rudder control horn. En-
sure both base plates are fully seated against the
rudder before the glue fully cures.
14. Install the remaining 4-40 ball link as shown.
15. Before the epoxy has fully cured ensure that full
rudder travel can be achieved. If the control
horns come in contact with the fuse at full throw
they may not be properly centered in the slots.
10. Apply 30 minute epoxy only to the portion of
the control horn that will be glued into the slots
in the rudder. Apply epoxy to both sides of each
control horn for a secure glue joint.
11. Apply 30 minute epoxy to the rudder as shown.
This will only be done on the side of the rudder
that has the corresponding base plate already
installed on the control horn.
