Aerotech HexGen HEX300-230HL, Руководство по оборудованию

Страница: 25 / 44

Chapter 3: Electrical Specifications and Installation
DANGER : To decrease the risk of electrical shock, injury, death, and damage to the
equipment, obey the precautions that follow.
l
Electrical installation must be done by qualified personnel.
l
Before you do maintenance to the equipment, disconnect the electrical power.
l
Before you connect wires to this product, disconnect the electrical power.
l
Restrict operator access to the base and tabletop while the system is connected to a
power source.
l
Applications that do require operator access to the HEX300-230HL must be restricted
to qualified and trained personnel.
l
Make sure that all components are grounded correctly and that they obey the local
electrical safety requirements.
l
It is the responsibilty of the system integrator or qualified installer to determine and
meet all safety and compliance requirements when they integrate the HEX300-230HL
into a completed system.
WARNING : To prevent damage to the equipment and decrease the risk of electrical
shock and injury, obey the precautions that follow.
l
Only trained operators should operate this equipment.
l
Use this product only in environments and operating conditions that are approved in
this manual.
Electrical installation requirements will vary depending on product options. Installation instructions
in this section are for HEX300-230HL stages equipped with standard Aerotech motors intended for
use with an Aerotech motion control system. Contact Aerotech for further information regarding
products that are otherwise configured.
Aerotech motion control systems are adjusted at the factory for optimum performance. When the
HEX300-230HL is part of a complete Aerotech motion control system, setup usually involves
connecting the HEX300-230HL to the appropriate drive chassis with the cables provided. Labels on
the system components usually indicate the appropriate connections.
If system level integration was purchased, an electrical drawing showing system interconnects has
been supplied with the system (separate from this documentation).
The electrical wiring from the motor and encoder are integrated at the factory. Refer to the sections
that follow for standard motor wiring and connector pinouts.
HEX300-230HL Hardware
Manual Chapter 3: Electrical Specifications and
Installation
www.aerotech.com 25