20
Figure 43
Figure 44
6.1.11 In light winds, secure the base tube with the harness straps and park the ultralight against the
wind. The angle of attack of the wing should be approximately 0 degrees or less. In fresh or gusty winds,
position the ultralight so that the wind direction in relation to the ultralight is to the side and slightly to
the rear. Move the base tube towards the front strut and lower the wing facing downwind towards the
ground. Fix the base tube to the front strut
(Fig. 44).
6.2 ATTACHING
Fox-13TL
WING TO THE TRIKE
6.2.1 Check that the ignition switch and the key are in off position.
Install the wing mount bracket on the
front lower pylon as shown on figures 45 and 46.
Figure 45
Figure 46
6.2.2 Position the wing on its control frame, facing into the wind, with the nose on the ground and the
nose cone removed.
6.2.3 Install the mount bracket on the wing (see item 6.1.2).
6.2.4 Turn the propeller so that it is positioned horizontally, this will protect it from possible damage.
Detach the front strut from the front lower beam. Press the front strut push pins buttons and fold the
front strut tube in as far as it will go. Tilt the upper pylon down and place the lower tip of the front strut
on the pilot's seat.
6.2.5 Wheel the trike behind the wing. Lift the control frame of the wing up and rest the base tube on
the wing mount bracket. Fasten straps of the mount bracket around the base tube
(Frig. 47).
6.2.6 Attach the front strut to the front lower beam channel using a quick-pin
(Fig. 48).
Содержание ANT
Страница 2: ...2...
