Aerohive Networks Aerohive APs, Справочник по аппаратуре

Страница: 64 / 93

Hardware Reference Guide 63
AP110
AND
AP120 P
RODUCT
O
VERVIEW
Ethernet Port
The pin assignments in the PoE (Power over Ethernet) 10/100/1000Base-T/TX Ethernet port follow the
TIA/EIA-568-B standard (see
Figure 2 on page 20 ). The port accepts standard types of Ethernet cable—cat3,
cat5, cat5e, or cat6—and can receive power over the Ethernet cable from power sourcing equipment (PSE) that
is 802.3af-compatible. If you use cat5, cat5e, or cat6 cables, the ETH0 port can also support 802.3at-compliant
PSE. Such equipment can be embedded in a switch or router, or it can come from purpose-built devices that
inject power into the Ethernet line en route to the HiveAP. Because the PoE port has autosensing capabilities,
the wiring termination in the Ethernet cable can be either straight-through or cross-over.
Reset Button (Continued) To return the configuration to the factory default settings, hold it down
for at least 5 seconds. After releasing the button, the status indicator
goes dark as the system reboots. Then it glows blue while the device
boots and the system performs a self-test. After the firmware finishes
loading and the HiveAP is ready to serve clients, the status indicator
glows white.
To disable the reset button from resetting the configuration, enter this
command:
no reset-button reset-config-enable
Pressing the
button between 1 and 5 seconds will still reboot the HiveAP, but
pressing it for more than 5 seconds will not reset its configuration.
ETH0 PoE Port The 10/100/1000-Mbps Ethernet port—ETH0—receives an RJ-45
connector. The HiveAP can receive power through an Ethernet
connection to the ETH0 port from PSE (power sourcing equipment)
that is compatible with the 802.3af standard and the forthcoming
802.3at standard. Aerohive provides suitable PoE injectors as an
optional accessory. (If you connect the HiveAP to a power source
through the power connector and the ETH0 PoE port simultaneously,
the device draws power through the power connector and
automatically disables PoE.)
The ETH0 port is compatible with 10/100/1000Base-T/TX and
automatically negotiates half- and full-duplex connections with the
connecting device. It is autosensing and adjusts to straight-through
and cross-over Ethernet cables automatically. For details, see
"Ethernet Port" on page 63 .
48VDC Power Connector The 48-volt DC power connector (0.3 amps), with a voltage range of
36 to 57 volts DC, is one of two methods through which you can power
the HiveAP (the other is PoE). To connect it to a 100 – 240-volt AC
power source, use the AC/DC power adaptor that is available as an
extra accessory. Because the HiveAP does not have an on/off switch,
connecting it to a power source automatically powers on the device.
Table 1 AP110 and AP120 component descriptions (Continued)
Component Description