Hardware Reference Guide
39
AP320 P
RODUCT
O
VERVIEW
ETH0 10/100/1000 Mbps PoE
Port
and ETH1 10/100/1000 Mbps
Port (continued)
You can configure ETH0 and ETH1 as two individual Ethernet interfaces,
combine them into an aggregate interface to increase throughput, or combine
them into a redundant interface to increase reliability. You can connect the
AP320 to a wired network or to a wired device (such as a security camera)
through these ports using bridging. They are compatible with
10/100/1000Base-T/TX and automatically negotiate half- and full-duplex
connections with the connecting device. They are autosensing and adjust to
straight-through and cross-over Ethernet cables automatically. For details,
see
"Ethernet and Console Ports" on page 40
.
48VDC Power Connector
The 48-volt DC power connector (0.625 amps) is one of two methods
through which you can power the AP320. To connect it to a 100 – 240-volt
AC power source, use the AC/DC power adaptor that is available as an extra
option. Because the AP320 does not have an on/off switch, connecting it to a
power source automatically powers on the device.
Console Port
You can access the CLI by making a serial connection to the RJ-45 console
port. The management station from which you make a serial connection to
the AP320 must have a VT100 emulation program, such as Tera Term Pro
©
(a
free terminal emulator) or Hilgraeve Hyperterminal
®
(provided with
Windows
®
operating systems). The following are the serial connection
settings: bits per second: 9600, data bits: 8, parity: none, stop bits: 1, flow
control: none. For details, see
"Ethernet and Console Ports" on page 40
Device Lock Slot
You can physically secure the AP320 by attaching it to a mounting plate that
is clipped to a ceiling track and then using a screw with a unique head design
to fasten the AP320 to the mounting plate through the device lock slot. The
screw and special screw driver that fits the slot on the screw head are
included in the mounting kit. For more information, see
Reset Button
The reset button allows you to reboot the device or reset the AP320 to its
factory default settings. Insert a paper clip, or something similar, into the
Reset pinhole and press the reset button. To reboot the device, hold the
button down between 1 and 5 seconds. To return the configuration to the
factory default settings, hold it down for at least 5 seconds. After releasing
the button, the Power LED goes dark as the system reboots. Then it pulses
green while the firmware loads and the system performs a self-test. After
the software finishes loading, the Power LED glows steady green.
To disable the reset button from resetting the configuration, enter this
command:
no reset-button reset-config-enable
Pressing the button
between 1 and 5 seconds will still reboot the AP320, but pressing it for more
than 5 seconds will not reset its configuration.
The rear surface of the AP320 is used for heat dissipation to reduce the internal temperature.
Consequently, it can become hot, so use caution when handling it.
Table 1 AP320 component descriptions (Continued)
Component
Description
Содержание Aerohive APs
