Aerohive Networks Aerohive APs, Справочник по аппаратуре

Страница: 34 / 93

Hardware Reference Guide 33
M
OUNTING THE
AP340
Suspended Mount
You can suspend the AP340 from a horizontal beam, post, strut, or girder. As well as the mounting plate, you
need a quad-toggle, a 1.5 mm (0.059 inch) wire rope with hook, and a locking device. ERICO
®
supplies these
items in its CADDY
®
SPEED LINK product line. The part number for the quad-toggle is SLD15QT250 and that
for the set that includes the wire rope, hook, and locking device is SLD15L2T. These items are available through
various suppliers.
1. With the recessed side of the mounting plate facing downward, insert the four ends of the quad-toggle
through holes in the mounting plate.
2. Turn the AP340 face down and attach it to the mounting plate (see Figure 16 ).
Figure 16 Connecting the quad-toggle and AP340 to the mounting plate
3. Draw the wire rope over a support beam, fasten the hook around the wire, and pull the wire until the hook
is snug against the underside of the beam.
4. Push the plain end of the wire rope—the end without the hook—through the side hole in the locking device
in the direction indicated by the arrow on its side, and then pass it through the loop at the end of the
quad-toggle.
5. Insert the wire rope back through the center hole in the locking device, and then continue pulling it through
the locking device until the AP340 is suspended at the height you want (see Figure 17 on page 34 ).
The center tube that runs through the locking device is designed to allow you to pull the rope wire up
through it while preventing the rope from slipping back down. If you ever pull too much rope through and
need to pull it back down, use a tool such as a screw driver to press against the inner tube in the locking
device to release the rope. Then you can pull it back out (see "Height Correction" on page 34 ).
5 GHz ( A) 5 GHz (B) 5 GHz ( C)
To secure each of the four strands to the mounting plate:
1. Insert the metal cleat at the end of a strand through a hole in the plate.
2. Sliding the oblong washer along the strand, pass it through the hole.
3. Pull the strand upward to lock the cleat and washer against the
underside of the plate.
To attach the AP340 to the mounting plate:
1. Align the tabs on the plate with the
wider, circular section of the keyhole-
shaped slots on the underside of the
device, which is face down as shown.
2. Push the tabs into the slots and slide
the AP340 toward its port panel. This
repositions the tabs in the narrower,
rectangular section of the slots and
holds the device firmly in place below
the mounting plate.
1
2
Mounting plate
The recommended
holes for the four
strands are shaded in.