Aero Easy Cover, Руководство по установке

Страница: 5 / 40

5
Easy Cover ®
Installation Instructions
Step 1a
Installing End Plates and Wind Defl ector

 



  

1) See Figure 1.
Install 3/8-16 x 1 carriage bolts (3) and 3/8-16 Nylon hex nuts (4) in the driver's side and
passenger's mounting plates (1). Do not tighten.
2) Slide end plates (1) into wind defector's extrusion. Do not tighten.
3)
Carefully place assembly onto the cab shield or top rail and position at the
farthest point forward. This will keep the air from coming in under the wind
defl ector (2) to a minimum.
3) See Figure 2.
Move the end plates inward until they are against the cab
shield or top rail. Lift rear of assembly until the aligning notch is even with the
top rail. Clamp driver's side end plate into place.
4)
Using the end plate as a template, drill three 13/32" holes through the top rail
where square holes reside.
5)
Secure driver's side end plate with 3/8-16 x 1 hex bolt (5), 3/8 lock washer (6),
and 3/8-16 Nylon hex nut (7).
6)
Repeat Steps 4 and 5 for passenger's side end plate (1).
7)
Tighten nuts on carriage bolts holding the wind defl ector (2).
Index Description Qty
1 End Plates (DS & PS) 2
2 Wind Defl ector 1
3 3/8-16 x 1 Carriage Bolts 4
Index Description Qty
4 3/8-16 x 1 Hex Bolt 6
5 3/8-16 Nylon Hex Nut 10
Figure 1
1
3
5
2
Driver's Side Shown
Aligning Notch
Figure 2
Square Holes referred to in Step 4
  


