Aero Easy Cover, Руководство по установке

Страница: 25 / 40

25
Easy Cover ®
Installation Instructions
Step 5b
Installing Underbody Spring Assembly

  
   


1) Mark the rear edge of the tarp housing or the mounting
plate in line with the tarp roll up bar on the driver's side and
passenger's side. Mark these points and call them (A).
2) Determine where you want the rear of the tarp to be when
it fully covers the box. Mark these points and call them (C).
3) See fi gure 30. Find a point at the side of the box that is
the same distance from A and C. This is point B, where the
spring assembly will be mounted. Mark this point on both
sides.
4) See Figure 31. Disassemble spring assembly by loosening
set screw at rear of assembly. Pull spring support shaft out
from the front of assembly.
5) See Figure 31. Place spring assembly housing up
underneath dump body aligned at point B. Rest the top edge
against the bottom of the dump body. Once in place, trace the
holes onto the dump body.
6) Drill four 13/32" holes and the 1 1/8" hole with a hole saw.
  

7) See Figure 32. Bolt spring assembly housing to the dump
body using 3/8-16 x 1 hex bolt (3), 3/8 fl at washer (4), and
3/8-16 nylon hex nut (5). If optional plate aluminum cover
(6) is used, place it on the outside of the dump body before
bolting in place.
8) Re-assemble spring assembly.
9) Repeat Steps 4 - 7 for passenger's side.
#
$
$
%
2NCEG6QRQH
$TCEMGV#ICKPUV
$QVVQOQH$QF[
FKCOGVGT*QNG
#RRTQZKOCVGN[
Figure 30
5GV5ETGY
Figure 31
Index Description Qty
1 Flange Mounted Spring (driver side) 1
2 Flange Mounted Spring (passenger side) 1
3 3/8-16 x 1 1/4 Hex Bolt 8
Index Description Qty
4 3/8 Flat Washer 16
5 3/8-16 Nylon Hex Nut 8
6 Plate Aluminum Cover (optional) 2
Figure 32
3 4 6 4 5 1 2