Advantech PCA-6157, Руководство пользователя

Страница: 62 / 123

Chapter 5 SCSI Drive Installation 55
YES Go to c.
NO Power down all units in the system.
Make sure the hard drives have different ID numbers
(boot drive should have lowest ID).
Make sure both ends of the SCSI bus are terminated.
Check all cable and power connections.
Check CMOS setup.
Boot system.
Go to a.
c. If boot is still unsuccessful, go to the following item.
• THE DEVICE DRIVER DOES NOT RECOGNIZE ONE OF
THE NON-BOOT SCSI PERIPHERALS (system may lock up).
a. Make sure the drivers were installed in the correct sequence.
b. Make sure the drivers’ CONFIG.SYS line has the correct
path to the drivers.
c. Power down all units in the system.
d. Make sure the hard drives have different ID numbers (boot
drive should have lowest ID).
e. Make sure both ends of the SCSI bus are terminated.
f. Check all cable and power connections.
g. Boot the system.
• THE COMPUTER LOCKS UP WHILE TRYING TO LOAD
DOSCAM.SYS WITH EMM386.
a. Load DOSCAM.SYS before EMM386. The only adverse
effect is that the driver may not then be loaded high.