Chapter 5 SCSI Drive Installation 69
7. To make sure that the installation was successful, open the
productivity folder on the OS/2 Desktop, then double-click the
OS/2 System Editor to start the editor. Open the CONFIG.SYS
file and find the line:
BASEDEV=OS2CAM.ADD /V
Check that the file OS2CAM.ADD is in the OS/2 directory on
the boot drive.
Installing OS2CAM.ADD and OS/2 (from a floppy) to a SCSI
Hard Drive
In this case, since OS/2 will be installed from a floppy disk, it is
not required that the driver be present to install the operating
system (as is the case when installing from a CD-ROM).
1. After the installation of OS/2 is complete and the WorkPlace
Shell desktop is built, open the system setup folder and select
(double click on) the Device Driver Install icon.
2. Insert the floppy disk containing the NCR device driver in the
source drive, then click on the change button for the destination
directory
3. Choose OS2 and click on the set button.
4. Click the install button.
5. Choose the NCR OS/2 2.X driver from the list provided by
clicking on it once. The choice will be highlighted. Then click
the OK button, then the EXIT button.
6. To make sure that the installation was successful, open the
productivity folder on the OS/2 Desktop, then double-click the
OS/2 System Editor to start the editor. Open the CONFIG.SYS
file and find the line:
BASEDEV=OS2CAM.ADD /V
Check that the file OS2CAM.ADD is in the OS2 directory on
the boot drive.
7. Continue with the OS/2 installation process as documented in
the OS/2 Installation Guide.
Содержание PCA-6157
