Advance acoustic Adhancer 56316001(W32-C), Руководство по обслуживанию

Страница: 34 / 74

32 - FORM NO. 56043111 - Adhancer
™
SQUEEGEE SYSTEM
SERVICING THE SQUEEGEE
If the squeegee leaves narrow streaks or water, the blades may be dirty or damaged. Remove the squeegee, rinse it under warm water and inspect the blades.
Reverse or replace the blades if they are cut, torn, wavy or worn.
To Reverse or Replace the Rear Squeegee Wiping Blade:
1 See Figure 2. Raise the squeegee tool off the fl oor, then unsnap the Center Latch (23) on the squeegee tool.
2 Remove the Tension Straps (22) .
3 Slip the rear blade off the Alignment Pins (24) .
4 The squeegee blade has four working edges. Turn the blade so a clean, undamaged edge points toward the front of the machine. Replace the blade if all four
edges are nicked, torn, or worn to a large radius.
5 Install the rear blade following the above steps in reverse order, then adjust the squeegee angle as described below.
To Reverse or Replace the Front Squeegee Blade:
1 Raise the squeegee tool off the fl oor, loosen the two Thumb Nuts (25) , disconnect the Recovery Hose (19) , then remove the squeegee assembly from the
mount.
2 Remove both rear tension Straps (22) .
3 Remove all the wing nuts that hold the front blade in place, and then remove the front tension strap and front blade.
4 The squeegee blade has four working edges. Turn the blade so a clean, undamaged edge points toward the front of the machine. Replace the blade if all four
edges are nicked, torn, or worn to a large radius.
5 Install the front blade following the above steps in reverse order, then adjust the squeegee angle as described below.
ADJUSTING THE SQUEEGEE ANGLE
Adjust the squeegee angle as follows whenever a blade is reversed or replaced, or if the squeegee is not wiping the fl oor dry.
1 Park the machine on a fl at, even surface and lower the squeegee.
2 While moving the machine forward slowly, turn the squeegee adjustment Knob (26) until the rear squeegee blade folds over evenly across the entire width of the
squeegee as shown in Figure 2.
FIGURE 2