Advance acoustic 56314009, Руководство по обслуживанию

Страница: 13 / 79

FORM NO. 56043089 - AquaRide
™
- 11
KNOW YOUR MACHINE DESCRIPTIONS:
Recovery Tank Cover (1) – Open to access Recovery Bladder for rinsing and/or cleaning Float Cage.
Solution Tank Fill Cover (2) – Open to fi ll the solution tank, only use low-sudsing liquid detergents designed for carpet extraction. The area around
the recovery bladder inside the recovery tank also holds solution. Total capacity is 40 gallons (151 Liters).
Operator’s Seat (3) – The machine operator sits here. The seat has a safety switch which prevents the machine from moving without an operator
in the seat.
Solution Tank Drain Hose (4) – Used to empty the solution tank.
Steering Wheel Tilt Adjust Knob (5) – Push down on this knob to adjust the Steering Wheel up or down.
Brake Pedal / Parking Brake (6) – Push down to stop machine. NEVER leave machine unattended without setting Parking Brake.
Solution Spray Jets (7) – Based upon which extraction mode is selected (maintenance or restoration) the solution will be sprayed out one of the
two different jets.
Drive Pedal, Directional / Speed (8) – The operator can make the machine go forward by pushing forward on it, or reverse by pulling backward on
it. The speed is variable depending on how far forward or backward the pedal is moved.
Vacuum Shoes (9) – Removes excess solution from carpet after cleaning.
Drive and Steer Wheel (10) – Wheel drive motor attached to this wheel to propel machine either forward or reverse. Also attached to Steering
Wheel for steering left or right.
Wheel Drive Circuit Breaker (11) – Provides overload protection to machine’s wheel drive motor, 45 Amp. If it trips, it will pop out. To reset, wait
one minute and press the button back in. If any breaker trips repeatedly, have the machine serviced.
Control Circuit Circuit Breaker (12) – Provides overload protection, 10 Amp. If it trips, it will pop out. To reset, wait one minute and press the
button back in. If any breaker trips repeatedly, have the machine serviced.
Emergency Stop / Battery Disconnect (13) – Push in on lever to disconnect batteries.
Brush deck (14) – Contains brush drive motor(s), brush(s) and solution spray jets.
Rear Wheel (15) – These two wheels along with the drive wheel, support the machine. Power and steering are supplied through the front drive
wheel.
Battery Compartment (16) – Batteries stored here, fl ip seat panel up to access.
Recovery Bladder Shutoff Float (17) – Shuts off vacuum when recovery bladder is full.
Vacuum Motors’ Filter Housing (18) – Location of Vacuum Motors air intake fi lters.
Waste Water Bladder (19) – Contains waste water as it is recovered from carpet. Total capacity of XX gallons (XX Liters).
Solution Filter (20) – Filters solution prior to entering pump and being sprayed on fl oor.
Recovery Drain Hose (21) – Used to empty the recovery bladder.
Machine Battery Connector (22) – Batteries plug into this connector, disconnect to charge batteries.
Control Panel (23) – Operator Controls found here, see “FUNCTIONAL DESCRIPTION OF CONTROL SWITCHES”.
Debris Hopper (24) – Collects debris that has been swept up by the machine. Empty and clean daily.
Solution Control Valve (25) – This valve should be fully open whenever extracting. Only close this valve before removing the solution fi lter to
prevent loss of solution.
KNOW YOUR MACHINE