C N C 4 2 2 0 M a c hi ne Too l Op e ra t ion an d Te st
56
Graph parameters
Set other data in the above method and the page after setting follows:
12.2.2
PROGRAM RUNNING
Press the Auto
key to enter the auto mode, press the Setting key, and then press
or
to turn to the graph track page, press
to start drawing, and press the Start key to
make the program run automatically. You can verify the program by displaying the graph track, as
shown below:
Graph parameters
Coordinates selection
Scaling +
Graph center X (work piece coordinates) (mm)
Graph center Z (work piece coordinates) (mm)
Maximum X (mm)
Minimum X (mm)
Maximum Z (mm)
Minimum Z (mm)
X origin bias of graph (mm)
Z origin bias of graph (mm)
Data =
Auto mode