ADT-09 Series Motion Control Card
50
gold finger with eraser. Reinstall it.
2. Shut down, clear the card gold finger with eraser, and replace with other
available PCI slots.
5.2.3.
DIP switch repeated, Error Code 13
Possible cause
1. When multiple motion control cards of the same series are used, the DIP
switch is repeated.
Solution
1. Close the sample application, dial the DIP switches of multiple control
cards to different gears, and restart the sample program.
5.2.4.
Motion Control Card Not Detected, Error Code 14
The motion control card not detected as mentioned here is only considered in
the case where the control card has been properly assembled and the device manager
has detected the motion control card of the specified model.
Possible cause
1. The control card driver is not installed properly.
2. Run the sample application not as an administrator.
Recommended
solution
1. Uninstall and reinstall the motion control card driver. When uninstalling,
locate the specified control card device through the device manager. Then
right click and uninstall it.
2. Refer to
5.2.1 WinIO initialization failed, Error Code 9 for details.
3. For WIN7 and above system, Control Panel --> User Account and Family
Safety--> Change User Account Settings Message to "Never Notify"
4. Uninstall the control card driver and restart the PC. Enter the Advanced
Setup option by pressing F8 when booting; then select "Disable driver
signature enforcement" before entering the system, reinstall the driver, and
run the sample application as administrator
