Hybrid Standalone NVR User Guide
PTZ Activation
Select this feature to set Pan/Tilt/Zoom movement when an alarm occurs. Click the
Setup
button to
open the PTZ Activation screen for setting up the camera.
Figure 3-64
Delay
To avoid rerecording the same event, enter the number of seconds to wait after the event has ended
before a new recording can begin. This value ranges from 10s to 300s.
Tour
Enable the tour function to present an alternating display (much like a slideshow) of the channel(s)
you have set to record when a motion detect event occurs. The system supports 1/8-window tour.
Refer to section
3.8.7 Display
on page 84 for tour interval setup. However, the alarm tour has higher
priority than the tour setup you set in the Display screen.
Snapshot
Enable this function to take a snapshot image on the designated channel when an alarm occurs:
a.
Go to
Setting > Encode.
Select Snapshot as the activation mode, and then set corresponding
parameters.
b.
Go to
Setting > Network >FTP.
Set the FTP server information and the picture upload interval.
Enable the FTP function and click
Save
.
c.
Go to
Setting > Alarm.
Select the corresponding channel, and then enable the snapshot
function.
Note:
Activation Snapshot has higher priority than Schedule Snapshot.
Buzzer
Enable this function to sound an audible tone from the NVR when the alarm occurs.
Note:
A network alarm is an alarm signal using TCP/IP. You can use NET SDK to activate a network
alarm. There is no type, anti-dither or alarm upload function.
NVR32xx-P Series User Guide
83
