ADJ Products, LLC - www.adj.com - Vizi Beam Hybrid 2R Instruction Manual Page 21
3. Press UP or DOWN buttons, until “Lamp Off Time” is displayed,
and press ENTER.
4. “XXXX” will now be displayed. “XXXX” represents the running
time of the lamp the last time that the lamp was On.
5. Press ENTER or press MODE/ESC to exit.
Last Run Password - This will display the timer password.
1. Press the MODE/ESC button to access the main menu. Press
the UP or DOWN buttons so that “Information” is highlighted, then
press ENTER.
2. Press the UP or DOWN buttons until “Time Information” is dis-
played, press ENTER.
3. Press UP or DOWN buttons, until “Last Run Password” is dis-
played, and press ENTER.
4. The “Last Run Password” is 038.
5. Press ENTER or press MODE/ESC to exit.
Clean Last Run - This will allow you to clear the last run time of the
unit. You need to put in the Last Run Password before doing this.
Please see the section before this.
1. Press the MODE/ESC button to access the main menu. Press
the UP or DOWN buttons so that “Information” is highlighted, then
press ENTER.
2. Press the UP or DOWN buttons until “Time Information” is dis-
played, press ENTER.
3. Press UP or DOWN buttons, until “Clean Last Run” is displayed,
and press ENTER.
4. Either “Off” or “On” will be displayed, use the UP and DOWN but-
tons to toggle between.
5. Press ENTER to confirm your selection or press MODE/ESC to
exit.
Lamp Time Password - This will display the lamp timer password.
Vizi Beam Hybrid 2R
System Menu
ADJ Products, LLC - www.adj.com - Vizi Beam Hybrid 2R Instruction Manual Page 38
Vizi Beam Hybrid 2R
Error Codes
When power is applied, the unit will automatically enter a
“reset/test” mode. This mode brings all the internal motors to a
home position. If there is an internal problem with one or more
of the motors an error code will flash in the display in the form
of “XXer”, “XX” will represent a function number. For example,
when the display shows “03Er,” it means there is some type of
error with the channel 3 motor. If there are multiple errors during
the start-up process they will all flash in the display. For exam-
ple: if the fixtures has errors on channel 1 and channel 3 all at
the same time, you will see the error message flash “01Er”, and
“03Er repeated 5 times.
If an error does occur during the initial start-up procedure the
fixture will self-generate a second reset signal and try to realign
all the motors and correct the errors, if the errors persist after a
second attempt a third attempt will be made.
If after a third attempt all the errors have not been corrected the
fixture will make the following determinations:
1) 3 or more errors - The fixture cannot function properly with
three or more errors therefore the fixture will place itself in a
stand-by mode until subsequent repairs can be made.
2) Less than 3 errors - If the fixture has less than 3 errors, there-
fore most other functions will work properly. The fixture will
attempt to operate normally until the errors can be corrected by
a technician. The errors in question will remain flashing in the
display as a reminder of internal errors.
01Er – PAN movement error:
This message will appear after a fixture reset, if the pan-yoke’s
magnetic-indexing circuit malfunctions (sensor failed or magnet
is missing) or there is a stepper motor failure (defective motor
or a defective motor IC drive on the main PCB).
03Er – TILT movement error:
This message will appear after a fixture reset, if the tilt mag-
netic-indexing circuit malfunctions (sensor failed or magnet is
