– 12 –
4204 Relay Unit
(if installed in cabinet)
1.
Insert self-tapping screws (provided) in two adjacent raised cabinet tabs.
Leave the heads projecting 1/8".
2.
Hang the unit on the screw heads via two of the slotted holes at the rear of
its housing, as shown in Figure 2.
3.
The 4204's cover can be left off if the unit's DIP switch is set with its
position 1 "ON" (to the right) as shown in its instructions. The tampered
cover is neces sary for installations outside of the control's cabi net.
TAMPERE
NOT
TAMPERED
DETAIL C
4219/4229
COVER TAMPER
JUMPER
DETAIL A
SIDE VIEW OF
BOARD SUPPORTING SLOTS
CIRCUIT
BOARD
CABINET
DETAIL B
SIDE VIEW OF
LONG MOUNTING CLIPS
CONTROL
CIRCUIT
BOARD
Figure 2. Installing The PC Board in the Cabinet Alone, or (if used), With a 4204 Relay Unit
Figure 3. Installing The PC Board And RF Receiver Together In The Cabinet
