– 62 –
10 Input S/N: L
Axxx xxxx
5.
This prompt is displayed when the system has found the next zone
which needs to be enrolled.
The system will respond to the first serial number transmitted. A serial
number may be enrolled by one of two methods:
a) Enter the 7 digit serial number printed on the transmitter
or
b) Activate the transmitter by faulting or restoring the input you wish to
use for that zone (e.g., press a button, open or close a door, etc.).
If you do
not
wish to enroll the zone displayed, press the [#] key on
the keypad or the upper right-hand button on the program tool (a long
beep will be heard to verify). The following prompt will appear:
10 Learn S/N?
0 = No, 1 = Yes 0
To enroll now, enter "1" (Yes). If "0" (No) is entered, the following
prompt will appear if a program tool has already been programmed:
En te r Zn Nu m .
( 0 0 = Q u it) 1 2
Zone Number Entered
↑
Enter the next zone number to be enrolled (e.g., zone 12). The system
will search for that zone and will display the prompt shown in the
beginning of step 5. If you wish to exit the enroll mode completely,
enter 00 and press [
✱
].
10 Input S/N:
L
A 022-4064
3
Serial #
↑
Loop #
↑
The system will enroll the serial number of the first transmitter heard, add
the loop number entered to this serial number, display the serial and loop
numbers, and cause the keypad to beep twice.
If the serial and loop number combination is already present in the
system, a single long beep will be heard from the keypad. If this happens,
the system will not display the serial number, but will wait for a
transmission from another transmitter or transmitter loop input.
6.
The system will then enter a confirmation mode so that the operation
of the actual programmed input can be confirmed. Activate the loop
input or button that corresponds to this zone. We recommend that
you confirm the programming of every transmitter before
proceeding to the next zone.
10 Confirmed
A022-4064 3
When the system sees activity on the appropriate input, it will beep
three times and display the confirmation message. Press [
✱
] or the
upper left-hand button of the program tool when you are ready to enroll
the next transmitter.
At any time during this step, you may press the [
✱
] key on the keypad or
the upper left-hand button of the program tool if you are satisfied with the
serial and loop number combination that has been enrolled, regardless of
whether or not the enrolled input has been "confirmed." This will ready
the system to enroll the next transmitter.
If the incorrect transmitter has been enrolled, press the [#] key on the
keypad or the upper right-hand button of the program tool to delete the
serial number and return to the "LEARN S/N" prompt. A single long beep
will be heard from the keypad to verify pressing of the upper right-hand
button. Then, press "1" (Yes) or press the upper left-hand button of the
program tool (a single short beep will verify the system is ready for
enrolling) and re-activate the proper transmitter or transmitter loop input.
