ADB Safegate EREL, Руководство пользователя

Страница: 31 / 50

CAUTION
Do not touch the LEDs.
2. Make sure that all the parts are clean.
3. Make sure that the rear side of the new LED MCPCB (A) is clean. The heat dissipation must be maximised.
4. Put the LED MCPCB tightly against the cooling block (B). The heat dissipation must be maximised.
5. Connect the connector (C).
Note
•
On one side there is an additional connector. This connector is used for service and diagnostic and is marked
with a black dot. Do not connect the LED MCPCB to the connector with the black dot.
•
On fixtures with an arctic kit there is an additional connector for the connection of the arctic kit. This connector
has 4 poles. Connect the cable with the connector with 5 poles to the LED MCPCB.
Install - Step 2
1. Install the new protection rings (A), only if protection rings are delivered with the new optical kit.
2. Install the new optical block (B).
3. Make sure that the feet of the optical block fit in the cutouts of the LED MCPCB.
4. Install the new washers (C) and the new optical block screws (D). See §
Screws and torques (torque).
5. Install the optical cover. See § Part replacement - optical cover .
4.3.5 Part replacement - arctic kit (arctic kit option)
Parts: See § Exploded view .
•
Arctic kit, including spacers and screws
•
Optical cover gasket
•
Body gasket
AM.03.120e, Rev. 3.4, 2019/03/29 25
Copyright
©
ADB Safegate, All Rights Reserved