ADB Safegate EREL, Руководство пользователя

Страница: 17 / 50

3.0 Install or replace the fixture
The procedure only gives information on how to replace the complete fixture. For information on how to replace parts of the
fixture, see Part replacement .
3.1 Inspect on delivery
1. Inspect all packings for visible damage.
2. Open every damaged box and inspect the contents for damage.
3. Immediately fill a claim form with the carrier if any equipment is damaged.
4. Store the equipment in its original packing in a protected area.
Warning
Do not damage the cable insulation.
CAUTION
Do not unpack the equipment before the equipment is at the installation site to avoid damage due to
transportation and handling.
3.2 Storage
Store the fixture in its original packing in a protected area.
Indoor storage:
•
Storage temperature: -55°C to +50°C (-67°F to 131°F).
•
Humidity: <100% condensing.
For long storage periods (longer than one year), we recommend to energize the LED lights once a year at nominal intensity
(6.6Amps) for 20 minutes.
3.3 Installation
Warning
•
Only install the fixture on mounting supports:
•
That ADB SAFEGATE has approved
•
That are installed according to the Instruction Manual of the mounting support
•
Failure to do so can result in a highly dangerous situation of FOD, with potentially lethal consequences
•
Do not damage the cable insulation
•
Make sure the power to the series circuit is OFF when you install or remove any fixture.
•
Make sure that the installation, alignment and the position of the fixture complies with FAA Advisory circular AC
150/5340-30 (latest revision) and ICAO Annex 14, Volume I, Para 5.3.9 for runway edge lights.
AM.03.120e, Rev. 3.4, 2019/03/29 11
Copyright
©
ADB Safegate, All Rights Reserved