XVME-6500
USER
’S MANUAL
Acromag, Inc. Tel: 248-295-0310
- 78 -
http://www.acromag.com
- 78 -
www.acromag.com
8.0 XVME-9640 Rear-Transition Accessory Module
The optional XVME-9640 module may be installed into the rear slot directly
behind the XVME-6500 to easily access all of the available I/O on the
XVME-6500's P2, and optionally P0 connectors, as well as allow mSATA SSD
modules to be added for storage.
The following I/O is available on the front panel of the XVME-9640:
•
Two Gigabit Ethernet ports are available on the front panel's
optional RJ Point 5 connector (installed if the optional RJ0 connector
is installed). One adapter cable is included with the XVME-9640 to
connect from the front panel's RJ Point 5 connector to a standard
RJ45 connector.
•
One VGA port via standard DB-15 connector.
•
One DVI-D port via standard 24-pin DVI connector.
•
Two USB 2.0 ports. These ports use standard USB-A connectors.
•
The Upper PMC/XMC module's P4 user I/O from the XVME-6500's P2
connector is available via a 68-pin SCSI-3 connector.
The following I/O is available via internal connectors on the XVME-9640:
•
Stereo Audio Line-In & Line-Out are available via a 5-pin connector.
•
One software-selectable RS-232/RS-485 serial port is available via a
10-pin header.
•
The Lower PMC/XMC module's user I/O from the XVME-6500's
optional RJ0 connector is available via two optional high-speed
Samtec connectors (installed if the optional P0 connector is
installed).
The XVME-9640 also contains 2 mSATA sockets that allow 2 SSD drives to be
added while still remaining within a single VME slot. Using the software RAID
functionality of the QM87 PCH, these drives can even be setup as a RAID0/1
array if redundancy or extra speed is desired.
WARNING: mSATA requires P0 on both the XVME-6500 and XVME-9640 for
proper operation.
Note:
The standard XVME-9640 cannot be used in a backplane that uses VITA
31.1 Ethernet. A custom build option is available that isolates the Ethernet
lines for use in a VITA 31.1 system. Please consult factory for this option.
WARNING: The XVME-9640 should not be used with an XVME-6500 that is
built with the 'XVME-6300 Compatible I/O' option. For this option instead
use the XVME-9630 module (RTM for XVME-6300).
