Acer Network Device Altos R520, Руководство пользователя

Страница: 147 / 184

137
• If other software runs correctly on the system, contact your vendor
about the defective software.
No characters appear on the screen.
Check the following:
• Is the keyboard functioning? Test it by turning the “Num Lock”
function on and off to make sure the Num Lock light is
functioning.
• Is the video monitor plugged in and turned on? If you are using a
switch box, is it switched to the correct system?
• Are the brightness and contrast controls on the video monitor
properly adjusted?
• Is the video monitor signal cable properly installed?
• Does this video monitor work correctly if plugged into a different
system?
• Is the onboard video controller enabled in the BIOS setup?
• Remove all expansion cards and see if the system boots. If
successful, add the cards back in one at a time with a reboot
between each addition.
• Make sure the memory modules comply with the system
requirements.
• Make sure the memory modules have been populated according
to the system requirements.
• Remove and reseat the memory modules.
• Make sure the CPU comply with the system requirements.
• Make sure the CPU is populated according to the system
requirements.
If you are using a video controller board, do the following:
1 Verify that the video works using the onboard video controller.
2 Verify that the video controller board is fully seated in the
mainboard connector.
3 Reboot the system for changes to take effect.
4 If there are still no characters on the screen after you reboot the
system and POST emits a beep code, write down the beep code
you hear. This information is useful for your service representative.