AXS
–
FL Step Manual
AXS
–
STEP Manual vers 3.0
11
8.3
Installation of the LED (optional):
Remove the bottom plate from the
step by removing the Hex screws
size 8 and the 4 cross headed
screws PH2 (see step 1 and 2 of
chapter 9.1). Then remove front
yellow strip
Do not remove the side corners!
Push the wires through the hole
on the right side of the step, to
make it easier by bending the
wires beforehand
Use nose pliers to pick up the wires at the
bottom side.
Make sure you pick up both wires.
Pick up the two wire cable in the step from
the step cable loom. (pre wired at the front
of the step)
