AXS
–
FL Step Manual
AXS
–
STEP Manual vers 3.0
7
Always try to go as vertically as possible straight up from
the fixing point on the rear of the step to the fixing points
on the vehicles floor.
The M8 studs should be placed as vertical as possible
You can adjust the height of the step
under the vehicle by adjusting the front
brackets in the slot holes.
Take the flexible mounting brackets supplied with the step.
These brackets can be mounted in several ways. The brackets
should be used to fix the rear side of the step to the bottom of
the vehicle. It is recommended to find a strong point at the
vehicle floor. Mount the brackets in such a way that they bridge
the gap between step and vehicle floor / chassis.
This fixing requires some technical knowledge and own
interpretation.
Adjust the step to be horizontal under the vehicle.
Finally fit all bolts and nuts to mount the step completely.
When the possibility of attachement on the
back of the step is too far back, or there is a
fuel tank or something similar in the way, it is
possible to use a piece of L bar to extend the
back point of attachment.
In the case the flange of the
chassis is too far back, it is
possible to flip the brackets as to
place the step further forward.
