AXS
–
FL Step Manual
AXS
–
STEP Manual vers 3.0
14
•
Check wires and electrical connections for possible failures.
•
Clean all parts
•
Grease moving parts with MOTIP White PTFE grease or normal bearing
grease.
Close the bottom plate.
With step still in out position remove ty-rap at the rear of the step from both
rubber end caps.
Spray a good grease in the tube or use normal bearing grease with a long brush.
This is the most important part of the maintenance.
Close rubber caps again and fit with a new Tie-wrap
We strongly recommend MOTIP White PTFE grease part nr 090204 for all parts
in the step,
do not
use WD40 or silicon sprays
Other similar PTFE grease sprays can also be used.
This spray is also available at Acdeos under part number S150 310
10
Repair
The repair of the step is simple and can be done with the normal available
workshop equipment.
The most repairs can be done under the vehicle, but this manual describes a full assembly of a step
removed from the vehicle. We always recommend to remove the step from the vehicle as that save
time.
10.1
Disassembly
Remove the Philips and / or Hex
screws from the bottom plate
Remove the bottom plate by
putting a flathead screwdriver
under it at the edge
