AXS
–
FL Step Manual
AXS
–
STEP Manual vers 3.0
8
8.2
Electrical Installation
Find a good route for the cable to the front of the
vehicle or to the area where it will be connected to
the vehicles electrical system. The principal idea for
the routing of the cable loom is as follows: cable
should run under the vehicle to a place where you
can enter the vehicle. Try to find a dry place for the
4 pin connector in the cable loom inside the vehicle
to battery or power point and dashboard for
dashboard light. The cable to the door switch should
run directly to the door-pillar where the door switch
is mounted. Please refer to the electrical diagrams in
the rear of the manual appendix I.
There are two possible operations of the
step.
1 - Door switch. Steps moves out
automatically when the door opens
2 - Driver operated switch on the
dashboard where the driver operates the
step. In this case, it is still recommended
that the door switch in installed. Without
the door switch the driver could forget to
close the step when the door is closed,
and drive away with an open step.
Connect the green wire at the handbrake
switch or other signal indicating that the
vehicle is stationary. You need a signal
when the vehicle is stationary. The
handbrake switch is not supplied with the
step.
For safety reasons we recommend this
signal is used.
If you decide not to use this
signal Acdeos cannot
take any responsibility
for any unsafe
operation of the step.
Cable colours:
black
Ground
Red
Power (Use a 20 Amp fuse)
Green
Ground signal for operating
the step
