11: CFM
CFM configuration
151
•
CCM sequence number
: Enable or disable CCM sequence number. When enabled, a
MEP transmits CCMs with a sequence number that increases by one for each CCM.
When disabled, a MEP transmits CCMs with a sequence number set to zero.
•
Note:
A peer MEP should have sequence number enabled to allow a local MEP to
perform CCM based packet loss measurements.
•
Primary VID:
The Primary VLAN ID of the MEP. This is always one of the VLAN IDs
assigned to the MEP's MA. The value 0 indicates that either the Primary VLAN ID is that
of the MEP's MA, or that the MEP's MA is associated with no VLAN ID.
•
CCM and LTM priority:
The priority parameter for CCMs and LTMs transmitted by the
MEP (default value: the highest priority, i.e. the highest numerical value allowed to pass
through the Bridge Port for any of this MEP's VLAN IDs).
•
Lowest priority defect alarm:
The lowest priority defect alarm specifies the lowest
priority defect that is allowed to generate a Fault Alarm.
•
Fault notification alarm time:
The time that defects must be present before a Fault
Alarm is issued.
•
Fault notification reset time:
The time that defects must be absent before resetting a
Fault Alarm.
•
Enable fault propagation:
Use this MEP's status in fault propagation.
•
Propagate on port:
Specify the EVC client port to which the MEP status should be
propagated. That port should be also configured to perform EVC fault propagation for this
parameter to take effect.
Содержание EtherNID GE
Страница 1: ...1 EtherNID Administrator s Guide for the EtherNID EE EtherNID GE MetroNID TE MetroNID TE R...
Страница 112: ...7 Operations Administration and Maintenance OAM statistics 112...
Страница 145: ...10 Traffic shaper Traffic shaper statistics 145...
Страница 162: ...13 Appendix A Alarms Alarms 162...
