Abus SECVEST, Руководство по установке

Страница: 47 / 171

Configuration
47
3. This display shows:
•
the zones in which the detector has been
taught in
•
the zone type configured for this detector
•
the partition this detector monitors
•
the additional zone attributes that are available.
4. In addition, "SS:" (signal strength) and the received
signal strength are displayed. To have good
communication, this value should be higher than 3.
Note
If a detector have been successfully taught in,
the alarm panel displays the symbol next to the
zone number.
For a taught-in zone with a WAM (WAM function 3
sender receiver), "w2" is displayed, for example.
Detector is already used
Note
In rare cases, the message Detector is already
used may appear on the display when you are
teaching in a detector, after you have received
confirmation of the teach-in process, because the
detector sends its signal more than once.
In this case the message can be ignored.
This detector may already be taught in in another
zone.
Deleting detectors or de zone information
1. Select the zone in which the detector is registered.
2. Select:
•
Delete Detector ID when you only wish to
delete the detector
•
Default Zone when you wish to delete the
detector and the zone information.
3. Confirm the selection with Next .
4. Confirm the security prompt with Yes to delete the
detector/zone or Back if you are not sure.
Delete All (alarm panel only)
1. Select Delete All .
2. Confirm the selection with Next .
3. Confirm the security prompt with Yes to delete the
detector/zone or Back if you are not sure.