preparatIons, InstallatIon and takIng Into operatIon
11
DANGER!
Always observe the 5 golden rules of electrical installation:
1. Cut off all voltage sources
2. Secure all cut-off devices
3. Verify absence of voltage
4. Ground and short-circuit
5. Cover or bar access to adjacent components under voltage
Always deactivate the MCB allocated to the wallbox in the domestic power
supply and the internal RCCB(s) before you begin installation. Also ensure
that the MCB(s) and RCCB cannot be reactivated during installation. Other-
wise, there is a risk of severe injury through electric shock or even death!
Proceed as follows to drill the holes using the mounting plate:
1. Ensure that a sufficiently dimensioned power supply is available at the desired instal-
lation site. Otherwise, a power supply must be installed especially.
2. The mounting plate has pre-molded
cable inlets for the power supply on
its upper edge as well in the middle
of its surface. According to the power
supply at the installation site (and as
required), please remove one of the
plastic tongues intended for the pow-
er supply cable with a suitable pair of
pliers, a cutter or drill.
83
3. Place the mounting plate on the cho-
sen mounting surface: Use a spirit
level if required. Mark the drill holes.
4. Drill the mounting holes as marked (Ø
10 mm). Insert the supplied wall plugs
for the mounting screws if required.
