Installation and power supply connection
12
2. Loosen the four screws connecting the front part of the housing with the rear part:
Keep the screws in a safe place as you will need them again to complete installation.
3. Pull off the front part of the housing.
4. Remove the plastic tongue intended for the power
supply in the lower section of the rear part of the
housing using a suitable pair of pliers or a cutter.
5. Use the cutter to cut an opening to suit the power
supply cable into the rubber seal of the rear part
of the housing. If necessary, remove the rubber
seal for this purpose and place it back into the rear
part of the housing afterwards.
Mechanical installation of the charging station
1. Fix one screw (5 x 60 mm, screw head Ø 8 mm) in the top drill hole and hang the
upper mounting point of the charging station on it.
2. Fix the two lower mounting points using the other two screws (5 x 60 mm, screw
head Ø 8 mm).
3. Tighten the two lower screws so that the rear part of the housing is held in place
without being deformed by the tension applied to the mounting points.
Electrical installation of your charging station
The electrical connection of the
EVSE 563
to your domestic power supply and taking
it into operation must always be carried out by a qualified person or specialist electri-
cal contractor. All local standards and regulations regarding the installation of electrical
devices must be observed.
WARNING!
Read and make sure that you follow all safety notices in this manual and
those on the charging station itself!
• Now turn off the miniature circuit breaker (MCB) in your domestic power distribu-
tion box before you insert the power supply cable into the
EVSE 563
housing: The
power supply cable must be voltage-free under all circumstances before you or
any third person open the housing and/or manipulate the power supply in any way.
