6
Putting into operation
DANGER
Risk of injury due to unexpected start
The following instructions must be adhered to during all maintenance, servicing, assembly, disassembly and repair work:
• Switch off the power source.
• Close off the compressed air supply.
• Close off the gas supply.
• Disconnect all electrical connections.
NOTICE
• Note the following instructions:
3
Product description on page
EN
-
5
6 Putting into operation
6.1
Setting up the
xFUME
®
ABIROB
®
AF500
t
orch
neck
EN
12
1.
Screw the replaceable tip
adapter
(4)
onto
the torch neck (7) using the
wrench
(
9
).
2.
Screw the contact tip (2) into the tip
adapter
(4) and tighten using the wrench (9).
3.
Grease the torch neck 0 rings and insert the torch neck (7) into the connection module (8) until reaching the stop.
4. Insert the torch neck (7) into the connection module (8) until reaching the stop.
5.
Screw the bayonet nut (6) onto the
connection module
(8) locking the 3 pins in place.
6.
Insert the fume tube (5) into the bayonet nut (6) until reaching the stop.
7.
Screw the suction nozzle (3) into the fume tube (5) hand tight..
8.
Screw the gas nozzle (1) onto the tip
adapter
(4) hand tight.
Fig.
4
Setting up the
torch neck
xFUME
®
ABIROB
®
A
F500
9
10
Connection Module
Grease